NSX-T V6-3.2L DOHC (VTEC) (1997)
Steering Lock Removal/Installation
11. Push the lock pin. and pull out the steering lock assembly.
Installation:
1. Turn the key to "I", push the pin, and insert the steering lock assembly into the steering column until it clicks into place.
2. Loosely tighten the new shear bolt. Make sure the projection on the ignition switch is aligned with the hole in the steering column.
3. Insert the ignition key, and check for proper operation of the steering wheel lock and that the ignition key turns freely.
4. Tighten the shear bolt until the hex head twists off.
Steering Lock Removal/Installation
5. Install in the reverse order of removal. Install the 3P connector harness carefully because this harness serves as communication link.
6. After installing, check the immobilizer system.