NSX-T V6-3.2L DOHC (VTEC) (1997)
5. Screw two 8 x 1.0 mm bolts into the threaded holes in the differential housing cover to push it away from the final driven gear. Turn each bolt two
turns at a time to prevent cocking the differential housing cover excessively.
REASSEMBLE
NOTE:
-
If the limited slip differential clutch set was replaced, the 65 mm shim (differential housing cover side) and 112 mm shim (differential housing
cover side) must be adjusted.
-
Reassemble the parts in the same order and direction they were before disassembly.
-
Lubricate the clutch disc surface with transmission oil.