NSX-T V6-3.2L DOHC (VTEC) (1997)
/Page-5229006.png)
13. With a sponge, apply a light coat of glass primer around the edge of the rear window as shown, then lightly wipe it off with gauze or cheesecloth.
NOTE:
-
Do not apply body primer to the rear window, and do not get body and glass primer sponges mixed up.
-
Never touch the primed surfaces with your hands. If you do, the adhesive may not bond to the inner glass properly, causing a leak after the rear
window is installed.
-
Keep water, dust, and abrasive materials away from the primed surface.
14. With a sponge, apply a light coat of body primer to the original adhesive remaining around the rear window opening flange.
NOTE:
-
Do not apply body primer to the rear window, and do not get body and glass primer sponges mixed up.
-
Never touch the primed surfaces with your hands.
15. Thoroughly mix the adhesive and hardener together on a glass or metal plate with a putty knife.
NOTE:
-
Clean the plate with a sponge and alcohol before mixing
-
Follow the instructions that came with the adhesive.
16. Before filling a cartridge, cut the end of the nozzle as shown.
17. Pack adhesive into the cartridge without air pockets to ensure continuous delivery. Put the cartridge in a calking gun, and run a bead of adhesive
around the edge of the rear window as shown.
