NSX V6-3.0L DOHC (1991)
9.
Backprobe the 14-P control box connector at terminal 3 and measure voltage to ground.
Is there about 9.5 volts?
Yes - Replace the control box.[ ]
No - Go to the next step.
10.
Disconnect the 14-P connector from the control box. Disconnect the handset from the console and take it to the trunk. Open the trunk, remove the
rubber plug from the socket in the underside of the transceiver, and plug the handset into that socket Then, press the power button on the handset.
11.
At the 14-P connector, check for voltage between terminal 3 and ground.
Is there about 9.5 volts?
Yes - Replace the control box.[ ]
No - Go to the next step.
12.
Disconnect the 25-P connector from the transceiver and leave the 14-P connector disconnected from the control box.
13.
Set the DVOM to ohms. At the 14-P connector, check for continuity between terminal 3 and ground.
Is there continuity?
Yes - Repair shorted wire between the 25-P transceiver connector and the 14-P control box connector.[ ]
No - Go to the next step.
