NSX V6-3.0L DOHC (1991)
18.
Disconnect the control box 13-P DIN pigtail connector from the DIN cable. Repeat step 17.
Is there continuity?
Yes - Go to the next step.
No - Replace the control box and 13-P DIN pigtail harness. (Harness is not available separately.[ ]
19.
Disconnect the other end of the DIN cable (between the DIN cable and power harness DIN connector) and repeat step 17.
Is there continuity?
Yes - Replace the transceiver (power) harness. (Combination DIN cable connector and power wire.[]
No - Replace the DIN cable (located between the power harness and pigtail harness.[ ]