NSX V6-3.0L DOHC (1991)
Seat Back: Customer Interest
Seat Back - Broken Cover Clip
YEAR
MODEL
VIN APPLICATION
1991
NSX
ALL
November 26, 1990
BULLETIN NO.
90-026
Broken Seat Back Cover Clip
PROBLEM
The tabs on the seat back cover clip break off leaving the bottom of the cover loose.
CORRECTIVE ACTION
Secure the seat back cover clip with the push-clips listed under PARTS INFORMATION.
1.
Slide the seat fully forward, then remove the two rear seat mounting bolts. Slide the seat fully rearward, then remove the two front seat mounting
bolts. Remove the lower seat belt anchor bolt. Adjust the seat back to full recline, disconnect the seat wire harness, then remove the seat.
2.
Place the seat on a clean. smooth surface with the headrest down and the white plastic seat back cover clip up.
3.
Position the white plastic seat back cover clip in its original position. then drill four 8.5 mm holes through the clip and the aluminum seat bucket
(one hole on either side of the original tab locations).
4.
Insert a push-clip in each hole and secure by pushing in the pin.
NOTE:
The clips can be removed by pushing the pin in further.
PARTS INFORMATION
Clip Assembly. 8 mm. P/N 91545-SE0-003 (four per seat)
WARRANTY CLAIM INFORMATION
