NSX V6-3.0L DOHC (1991)
8.
Remove the motor relay from the under-hood fuse/relay box. Connect the Auxiliary Window Switch as described in step 2 of "Solenoid Flushing."
While watching the filter screens on top of the solenoids, run the pump for two or three seconds. Brake fluid will flow from the filter screen of the
leaking solenoid. It is highly unlikely that more than one solenoid will be leaking. Replace only the one that leaks.
9.
Open the maintenance bleeder with the Bleeder T-wrench. Loosen all of the solenoid set-plate bolts. Remove the three bolts shown.
10.
To remove the leaking solenoid, first push it down to unstick the O-rings, then pull it up while holding the set-plate up slightly. Turn the solenoid
in the direction shown until it can be removed.
