NSX V6-3.0L DOHC (1991)
3. Use circlip pliers to remove snap ring B then remove the pulley.
4. Remove snap ring A and the field coil.
5. Install parts in the reverse order of removal, and.
-
Install the field coil with the wire side facing up (see above).
-
Clean the pulley and compressor sliding surfaces with non-petroleum solvent.
-
Check the pulley bearings for excessive play.
-
Make sure the circlip fits in its groove properly.
-
Apply locking agent to the threads on the center bolt.
-
Make sure that the pulley turns smoothly, after it's reassembled.