NSX V6-3.0L DOHC (1991)
4. Remove the engine oil cooler base assembly.
NOTE: Do not disconnect the hoses.
5. Lower the car.
6. Remove the strut bar.
7. Remove the intake manifold plate.
8. Remove the top cover.
9. Remove the ignition coil covers.
10. Remove the injector cover and the wire harness covers.
11. Remove the ignition coils and the connecters.
NOTE: There are front and rear ignition coils and covers. They can be identified by the mark FF (front) or RR (rear) printed on them. When
installing front and rear ignition coil covers, attach a rubber seal to the intake side.
