NSX V6-3.2L DOHC (2001)
Impact Sensor: Service and Repair
CAUTION:
- Do not damage the sensor wiring.
- Do not install used SRS parts from another car, When repairing an SRS, use only new parts.
- Carefully inspect the dash sensors for signs of being dropped or improperly handled, such as dents, cracks or deformation.
1. Disconnect the battery negative cable, then the positive cable.
2. Before disconnecting any part of the SRS wire harness, install the short connectors (RED).
3. Remove the dashboard lower cover.
Dash Sensor Removal
4. Pull back the carpeting, and disconnect the 2P connector between the dash sensor and SRS main harness.
Dash Sensor Removal
5. Remove the two dash sensor mounting bolts from the sensor bracket, then remove the dash sensor.
Installation
CAUTION:
- Be sure to install the harness wires so that they are not pinched or interfering with other car parts.
- Replace a sensor if it is dented, cracked or deformed.
- For the SRS to function properly, the right and left sensors must be installed on the proper sides.
