NSX V6-3.2L DOHC (2001)
Constant Velocity Joint: Service and Repair
DISASSEMBLY
1. Carefully clamp the driveshaft in a vise with soft jaws, then remove the set ring from the inboard joint.
2. Remove the boot bands. Take care not to damage the boot.
-
If the boot band is a locking tab type, pry up the locking tabs with a screwdriver and raise the end of the band.
-
If the boot band is a welded type or a low profile type boot band, carefully cut it off with a pair of diagonal cutters. Take care not to damage
the boot.
-
If the boot band is a double loop band type, raise the band bend as shown.