NSX V6-3.2L DOHC (VTEC) (1997)
- Be sure to keep the dryer 40-50 cm (16-20 in) away from the paint film.
2. Sanding
Lightly dry sand the whole area to be painted with #600, #800 sandpaper.
7. Blow off with compressed air, then clean with wax and grease remover.
WARNING:
-
Do not use high air pressure; use only an approved, 210 kPa (2.1 kg/sq.cm, 30 psi) air nozzle.
-
Wear goggles or safety glasses to prevent eye injury.
NOTE: Clean the whole surface to help the masking tape adhere securely.
8. Top coating
-
Remove dust with a tack cloth before spraying.
-
Spray the top coating. Spray until the primer surfacer is covered.
-
The coating thickness should be 30-35 microns.
WARNING:
-
Ventilate when spraying paint. Most paint contains substances that are harmful if inhaled or swallowed. Read the paint label before
opening the paint container.
-
Avoid contact with skin. Wear an approved respirator, gloves, eye protection and appropriate clothing when painting.
-
Paint is flammable. Store it in a safe place, and keep it away from sparks, flames or cigarettes.
-
Do not use high air pressure; use only an approved, 210 kPa (2.1 kg/sq.cm, 30 psi) air nozzle.
-
Wear goggles or safety glasses to prevent eye injury.
NOTE: For the recommended top coat paint, refer to "Example of repair materials".
Solid color: Color enamel + color clear coat
Metallic : Metallic enamel + clear coat
Pearl : Pearl enamel + clear coat
9. Drying
After top coating for about 10 minutes, then dry with an infrared dryer.
NOTE: Follow the paint manufacturer's specification to dry properly.