NSX V6-3.2L DOHC (VTEC) (1997)
NOTE: Use a rubber or wooden block and sand the surface evenly. Clean dirt and dust off thoroughly.
-
Wipe the surface clean and air blow.
-
Polish with a sponge buff using very fine compound. Move the polisher up and down and right and left using light pressure.
NOTE: To prevent off-color or fading, observe the following:
-
Do not use air polishers. Use an electric polisher at 1,500 rpm.
-
Use a sponge buff to polish the surface. Woolen buffs may cause the surface to become heated and scratches may result.
-
Use very fine compound which is soluble in water.
-
Polish until sanding marks disappear.
-
Polish again with very fine compound.
NOTE:
-
Do not use excessive force to hold the polisher against the surface.
-
Do not overheat the surface.
-
Apply wax (hard).