NSX V6-3.2L DOHC (VTEC) (1997)
-
Just before setting the front assembly, remove the oxide film from the welding surface of the replacement part and body using a stainless steel
wire brush.
-
Tighten the front assembly against the front pillar and side sill using the vise-grips, pliers, etc.
-
Place a jack under the front side frame end on each side and support it, and measure the positions for temporary attachment.
-
Check over the body dimensions.
12. MIG weld the several points in the clamped sections and temporarily fix the front assembly.
WARNING: To prevent eye injury and burns when welding, wear an approved welding helmet, gloves and safety shoes.
-
Measure the dimension, temporarily install the hood and fender, and check for difference in level and clearance.
-
Install the windshield and check for proper installation and alignment.
13. Perform the main welding.
WARNING: To prevent eye injury and burns when welding, wear an approved welding helmet, gloves and safety shoes.
-
Before welding, perform the trial welding following the welder manufacturer's instructions.
-
Clean the welding section with a stainless steel wire brush before welding.
-
The applicable welding methods in this step shall be the MIG welding, plug welding, and fillet welding.
-
Check the welding section for cracks.
-
Weld the side frame and side sill on each side.