NSX V6-3.2L DOHC (VTEC) (1997)
WARNING: To prevent eye injury, wear goggles or safety glasses whenever sanding, cutting or grinding.
10. Mold the related parts.
Reshape the front pillar-and-front floor joint using a hammer and dolly.
NOTE: Check the reshaped parts for cracks.
-
Keep the body level.
11. Set the new front assembly.
-
Drill the 8-10 mm (5/16"-3/8") holes for spot welding in the welding flange.
-
Remove the undercoat from the both sides of the welding section and expose the aluminum alloy base using a disc sander.
WARNING: To prevent eye injury, wear goggles or safety glasses whenever sanding, cutting or grinding.
-
Remove the paint film from the welding section of the body and clean off any oil spots using a shop towel soaked with wax and grease
remover.