NSX V6-3.2L DOHC (VTEC) (1997)
-
Front fender
-
Rear fender
-
Dashboard
2. Pull out and straighten the damaged area.
NOTE: Make sure that the right and left pillars are parallel to the windshield surface.
-
Check the door and rear hatch for proper opening and closing.
-
Attach the car to the frame straightener by tightening the underbody clamps located at the jack-up points on the bottom of the side sill, and the
side sill side flange.
-
To protect the car body from damage, place a piece of aluminum plate on each clamping section and tighten the clamps.
-
Before removing the side panel, pull out the damaged sections so that they are restored to the original shape.
-
Before pulling out the damaged sections, it might be necessary to heat them with an acetylene torch..
-
After pulling, check the door, windshield and rear window opening using the body dimensional drawings.
NSX-T (open top):
NOTE: Use of a roof panel positioning jig is recommended.