NSX V6-3.2L DOHC (VTEC) (1997)
7. With a brush, apply a light coat of glass primer around the edge of the glass.
NOTE: Scrape off excess glass primer with a putty knife after installing the new molding.
8. Degrease the inner surfaces of the new molding thoroughly, then apply a light coat of glass primer to the surfaces.
NOTE:
-
Apply glass primer around the entire groove of the new molding.
-
Do not apply glass primer to the outer surface.
9. Run a bead of adhesive in the groove of the molding.
10. Press the molding into position around the entire edge of the glass.
NOTE: Check that the molding is not wrinkled or lifted away at the corners.
11. Scrape or wipe the excess adhesive off with a putty knife or towel.