NSX V6-3.2L DOHC (VTEC) (1997)
Rocker Arm Assembly: Testing and Inspection
Inspection Using Special Tools
CAUTION:
-
Before using the special tool, make sure that the air pressure gauge on the air compressor indicates over 250 kPa (36 psi).
-
Inspect the valve clearance before rocker arm inspection.
-
Cover the timing belt with a shop towel to prevent getting oil on the belt.
-
Check the mid rocker arms of each cylinder at TDC.
1. Plug the relief hole with the special tool as shown.
2. Remove the 10 mm sealing bolt and washer from the inspection hole and connect the tools.