NSX V6-3.2L DOHC (VTEC) (1997)
Crankshaft: Service and Repair
Installation
NOTE: Before installing the crankshaft, apply a coat of engine oil to the main bearings and rod bearings.
1. Insert bearing halves in the engine block and connecting rods.
2. Lower the crankshaft into the block.
3. Install the thrust washers on the No. 3 journal. Oil thrust washer surfaces.
4. Install the bearings and caps. Tighten 9 x 1.25 mm cap bolts to 39 Nm (29 ft. lbs.).