NSX V6-3.2L DOHC (VTEC) (1997)
Clutch Overhaul
3. Remove the snap ring B with snap ring pliers, then remove the pulley.
NOTE:
^ Be careful not to damage the pulley and compressor during removal/installation.
^ Once the snap ring B is removed, replace it with a new one.
Clutch Overhaul
4. Remove the snap ring A and the field coil.
NOTE:
^ Be careful not to damage the field coil and compressor during removal/installation.
^ Once the snap ring A is removed, replace it with a new one.
5. Install parts in the reverse order of removal. and
^ Install the field coil with the wire side facing down.
^ Clean the pulley and compressor sliding surfaces with non-petroleum solvent.
^ Make sure the snap rings are in the grooves properly.
^ Apply locking agent to the threads on the center bolt.
^ Make sure that the pulley turns smoothly after it's reassembled.