NSX V6-3.2L DOHC (VTEC) (1997)
Timing Belt: Service and Repair
Installation
NOTE:
-
Install the timing belt in the reverse order of removal; Only key points are described here.
-
Clean the middle and lower covers before installation.
1. Set the timing belt drive pulley so that the No. 1 piston is at Top Dead Center (TDC). Align the mark on the teeth side of the timing belt drive
pulley to the pointer on the oil pump.
2. Set the front camshaft so that the No. 1 piston is at TDC. Align the TDC marks on the front exhaust camshaft pulley and front intake camshaft
pulley to the pointer on the back cover.
3. Set the rear camshaft pulleys so that the No. 1 piston is at TDC. Align the TDC mark on the rear intake camshaft pulley to the pointer on the back
cover. Align the rear exhaust camshaft pulley one half tooth clockwise past TDC.
4. Install the timing belt tightly in the following sequence:
(1) Timing belt drive pulley (crankshaft)
(2) Adjusting pulley