NSX V6-3.2L DOHC (VTEC) (1997)
Mode B
5. Reconnect the seat belt tensioner 3P connectors. Check continuity between body ground and each terminal for both seat belt tensioners.
-
If there is continuity, go to step 13.
-
If there is no continuity, go to step 6.
Mode B
6. Check continuity between body ground and each terminal of both dash sensors.
-
If there is continuity at any of the terminals, go to step 17.
-
If there is no continuity, go to step 18.
Mode B
7. Disconnect the cable reel 6P connector from the SRS main harness, then connect test harness C only to the cable reel side of the 6P connector.
Mode B
8. Check continuity between the No.4 terminal and body ground, and between the No.5 terminal and body ground.
-
If there is continuity, go to step 9.
-
If there is no continuity, the SRS main harness is faulty. Replace it and recheck the voltages according to the chart.