NSX V6-3.2L DOHC (VTEC) (1997)
Seat Belt: Service and Repair
Replacement
SRS wire harnesses are routed near the retractor.
WARNING: All SRS wire harnesses and connectors are colored yellow. Do not use electrical test equipment on these circuits.
CAUTION
-
Be careful not to damage the SRS wire harnesses when servicing the retractor.
-
Remove the short connector (RED) from the its holder and disconnect the SRS wire harness connector, then connect the short connector (RED) to
the tensioner connector.
NOTE: To prevent dust, wrap the SRS wire harness connector with a protective cover.
CAUTION: Check the seat belts for damage, and replace them if necessary. Be careful not to damage them during removal and installation.
1. Remove:
-
Seat
-
Center pillar trim panel
2. Remove the three anchor bolts, retractor bolt and retractor mounting bolt, then remove the seat belt and seat belt buckle.
CAUTION: When removing the retractor, do not touch the seat belt tensioner.
NOTE: When removing the anchor bolts and retractor bolt.