NSX V6-3.2L DOHC (VTEC) (1997)
Clutch Slave Cylinder: Service and Repair
REMOVAL
1. Disconnect the clutch hose from the slave cylinder. Plug the end of the clutch hose with a shop towel to prevent brake fluid from coming out.
CAUTION: Avoid spilling brake fluid on the painted surfaces, as it may damage the finish.
2. Remove the slave cylinder from the clutch housing.
INSTALLATION
Super High Temp Urea Grease (P/N 08798-9002).
Brake Assembly Lube or equivalent rubber grease.
1. Install the slave cylinder on the clutch housing.
2. Bleed the clutch hydraulic system:
-
Attach a hose to the bleed screw, then suspend the hose in a container of brake fluid.
-
Make sure there is an adequate supply of fluid at the master cylinder, then slowly pump the clutch pedal until no more bubbles appear at the