NSX V6-3.2L DOHC (VTEC) (1997)
Constant Velocity Joint: Service and Repair
DISASSEMBLY
1. To remove the boot band, pry up the locking tabs with screwdriver, and raise the end of the band.
NOTE: Carefully clamp the driveshaft in a vise with soft jaws.
CAUTION: Take care not to damage the boots.
2. Mark each roller and joint to identify the locations of rollers and grooves in the joint.
NOTE: Be careful not to drop the rollers when separating them from the inboard joint.
3. Remove both joints.
Outboard joint side only: Remove the circlip from the outboard joint groove, then remove the outboard joint and spring.