NSX V6-3.2L DOHC (VTEC) (1997)
1. Install the outboard boot to the driveshaft, then remove the vinyl tape.
2. Install the stop ring into the driveshaft groove.
3. Install the spider on the driveshaft by aligning the marks on the spider and end of the driveshaft.
4. Install the set ring into the driveshaft groove.
5. Fit the rollers to the spider with their high shoulders facing outward.
CAUTION:
-
Reinstall the rollers in their original positions on the spider.
-
Hold the driveshaft assembly pointed up to prevent the rollers from falling off.