NSX V6-3.2L DOHC (VTEC) (1997)
6. Remove the screws, then remove the front pillar retainer.
NOTE: If necessary, remove the glass guide clip from the front pillar retainer.
7. Scrape the old sealant from the body bonding surface with a putty knife.
NOTE: Do not scrape down to the painted surfaces of the body.
8. Clean the body bonding surface with a sponge dampened in alcohol.
NOTE: After cleaning, keep oil, grease and water from getting on the surface.
9. If the old front pillar retainer is to be reinstalled, use a putty knife to scrape off all of the old sealant and the EPT sealer as shown, then clean the
front pillar retainer surface with alcohol where new sealant and EPT sealer are to be applied.