NSX V6-3.2L DOHC (VTEC) (1997)
NOTE: Be careful not to touch the windshield where adhesive will be applied.
7. With a sponge, apply a light coat of glass primer around the edge of the windshield as shown, then lightly wipe it off with gauze or cheesecloth.
NOTE:
-
Do not apply body primer to the windshield, and do not get body and glass primer sponges mixed up.
-
Never touch the primed surfaces with your hands. If you do, the adhesive may not bond to the windshield properly, causing a leak after the
windshield is installed.
-
Keep water, dust, and abrasive materials away from the primed surface.
8. Thoroughly mix all the adhesive and hardener together on a glass or metal plate with a putty knife.
NOTE:
-
Clean the plate with a sponge and alcohol before mixing.
-
Follow the instructions that come with the adhesive.
9. Before filling a cartridge, cut the end of the nozzle as shown.
10. Pack adhesive into the cartridge without air pockets to ensure continuous delivery. Put the cartridge in a calking gun, and run a bead of adhesive
around the edge of the windshield as shown.