RDX L4-2.3L Turbo (2008)
6. Remove the door panel with as little bending as possible to avoid creasing or breaking it.
^
Start at the bottom edge of the door panel, release the clips with a commercially available trim pad remover.
^
Detach the upper clips.
^
Starting at the rear, pull the door panel upward.
^
Disconnect the seat position memory switch connector ('08-09 models only).
NOTE:
The inner handle cable and the latch cable are connected to the inner handle. Do not pull the door panel up too far, or these cables will be damaged.
7. While holding the door panel away from the door remove the inner handle from the door panel by detaching the clips. Then remove the door panel.
