RDX L4-2.3L Turbo (2008)
Power Mirror Motor: Service and Repair
Power Mirror Actuator Replacement
1. Remove the mirror holder.
2. Remove the visor.
3. Remove the power mirror.
4. Disconnect the 8P (left side) or 14P (right side) connector from the mirror.
5. Remove the three TORX screws using a tamper-proof T10 TORX bit, then remove the actuator (A).
6. Disconnect the 8P (left side) or 14P (right side) connector from the mirror.
7. Remove the connectors (A) and (B) (right side), then remove the screw and separate the harness (C) from the power mirror.
8. Route the wire harness of the new actuator through the hole in the bracket and the gasket.
9. Install the actuator, the harness clip, and the gasket in the reverse order of removal.
