RDX L4-2.3L Turbo (2008)
Head Rest: Testing and Inspection
Front Seat Active Headrest Inspection
NOTE: If the vehicle has been in a collision, always inspect the active headrests, even if they appear reusable, by doing the following procedure.
Resetting Headrest Position
1. Push the head restraint (A) forward fully from the locked position to return the inside inertia lock (B).
2. Slowly raise the head restraint into the normal position.
Inspection
3. Fold the seat-back forward, then recline the seat-back to the first lock position, and adjust the head restraint to the head restraint position.
4. Apply masking tape on the top of the head restraint.
5. Make marks (A) on both sides at 250 mm (9.84 in.) upward from the roots of the head restraint frame (B) along the back of the head restraint (C)
surface. Make a center of these points as a datum point (D).
