RDX L4-2.3L Turbo (2008)
Wheel Speed Sensor: Service and Repair
Wheel Sensor Replacement
Front
1. Make sure the ignition switch is OFF.
2. Release the connector holding clamps (A), then disconnect the wheel sensor connector (B).
3. Remove the clips, the bolt, and the wheel sensor (C).
4. Install the wheel sensor in the reverse order of removal, and note these items:
-
Install the sensor carefully to avoid twisting the wires.
-
If the wheel sensor comes in contact with the wheel bearing, it is faulty.
5. Start the engine, and check that the ABS and the VSA indicators go off.
6. Test-drive the vehicle, and check that the ABS and the VSA indicators do not come on.
Rear
1. Make sure the ignition switch is OFF.
2. Disconnect the wheel sensor connector (A).