RDX L4-2.3L Turbo (2008)
Cruise Control Switch: Testing and Inspection
Cruise Control Combination Switch Test/Replacement
SRS components are located in this area. Review the SRS component locations, and the precautions and procedures, in the SRS before doing repairs or
service.
1. Remove the driver's airbag.
2. Remove the steering wheel trim.
3. Remove the cruise control combination switch.
4. Check for continuity between the terminals in each switch position according to the table.
-
If there is continuity, and it matches the table, but switch failure occurred on the cruise control input test, check and repair the wire harness on
the switch circuit.
-
If there is no continuity in one or more positions, replace the switch.
5. Check for continuity between terminals No. 1, No. 2, and No. 3 on the switch. There should be continuity. If a failure occurs between terminals
No. 1, No. 2, and No. 3, replace the cruise control combination switch.
6. Check for continuity between terminals No. 4 and No. 10 on the switch. There should be continuity. If a failure occurs between terminals No. 4
and No. 10, replace the cruise control combination switch.
7. Check for continuity between the terminals in according to the table.
-
If there is continuity, and it matches the table, check and repair the wire harness on the switch circuit.
-
If there is no continuity in one or more positions, replace the switch.
