RDX L4-2.3L Turbo (2008)
7. Connect the engine wire harness connectors, and install the wire harness clamps to the intake manifold.
^
Four fuel injector connectors
^
Throttle actuator connector
^
MAP sensor connector
^
IAT sensor connector
^
Turbocharger bypass control solenoid valve connector
8. Install the fuel injector cover.
9. Install the charge air cooler.
10. Clean up any spilled engine coolant.
11. After installation, check that all tubes, hoses, and connectors are installed correctly.
12. Inspect for fuel leaks: Turn the ignition switch ON (II) (do not operate the starter) so the fuel pump runs for about 2 seconds and pressurizes the
fuel line. Repeat this operation two or three times, then check for fuel leakage at any point in the fuel line.
13. Refill the radiator with engine coolant, and bleed the air from the cooling system with the heater valve open.
