RDX L4-2.3L Turbo (2008)
14. Clean, and dry the water passage mating surfaces.
15. Apply liquid gasket, P/N 08717-0004, 08718-0001, 08718-0003, or 08718-0009, evenly to the engine block mating surface of the water passage.
Install the component within 5 minutes of applying the liquid gasket.
NOTE:
^
If you apply liquid gasket P/N 08718-0012, the component must be install within 4 minutes.
^
If too much time has passed after applying the liquid gasket, remove the old liquid gasket and residue, then reapply new liquid gasket.
16. Install the water passage (A) with a new O-ring (B).
NOTE:
^
Wait at least 30 minutes before filling the engine with oil.
^
Do not run the engine for at least 3 hours after installing the water passage.
17. Install the connecting pipe (A) with a new O-ring (B), then tighten the bolt (C).