RDX L4-2.3L Turbo (2008)
7. Remove the bolts (B) and nut (C).
8. Raise the vehicle all the way up on a lift.
9. Remove the under-floor TWC.
10. Remove the secondary HO2S.
11. Remove the splash shield.
12. Remove the intermediate shaft.
13. Remove the P/S heat shield.
14. Disconnect the engine oil pressure switch connector (A), the right front wheel sensor connector (B), and the CKP sensor connector (C), then
remove harness clamp (D).
15. Remove the water hose lower cover (E).
16. Remove the torque rod mounting bolts (A) from the oil pan.