RDX L4-2.3L Turbo (2008)
3. Remove the water valve lever from the heater unit:
^
Remove the screw and the plastic pan washer.
^
Detach the water valve cable from the lever.
^
Pull the lever off the heater unit.
4. Apply Molykote MH62 Grease to both sides of the lever's pivot seat area.
5. Reinstall the lever, reattach the water valve cable, and reinstall the washer and the screw with light torque. The washer should rotate easily.
6. Apply grease to the pin and the groove on the air mix control motor.
7. Reinstall the air mix control motor.
8. Reinstall the accelerator pedal module, and torque the nuts to 13 Nm (9.4 lb-ft).
Disclaimer
