RDX L4-2.3L Turbo (2008)
Oil Filter: Service and Repair
Engine Oil Filter Replacement
Special Tools Required
Oil filter wrench 07AAA-PLLA100
1. Remove the oil filter with the special oil filter wrench.
2. Inspect oil filter sealing surface and be sure all of the rubber seal is removed.
3. Inspect the threads (A) and rubber seal (B) on the new filter. Clean the seat on the filter base, then apply a light coat of new engine oil to the filter
rubber seal. Use only filters with a built in bypass system.
4. Install the oil filter by hand.
5. After the rubber seal seats, tighten the oil filter to 12 N-m (1.2 kgf-m, 8.7 lbf-ft).
6. After installation, fill the engine with oil up to the specified level, run the engine for more than 3 minutes, then check for oil leakage.
