RDX L4-2.3L Turbo (2008)
into the control lever hole through the shift cable end, and secure the control pin with the spring clip/washer.
21. Secure the shift cable bracket with the nuts.
22. Check the connectors for rust, dirt, or oil, clean, them if necessary then connect the connectors securely.
23. Install the intake air duct, the air cleaner housing, and the intercooler cover.
24. Install the battery base.
25. Install the battery tray, the battery, the battery cover, and the battery hold-down bracket, then reconnect the battery cables.
26. Turn the ignition switch to ON (II). Move the shift lever through all positions, and check the transmission range switch synchronization with the
A/T gear position indicator.
27. Check that the engine starts in P and N, and does not start in any other shift lever position.
28. Check that the back-up lights come on when the shift lever is in R.
29. Raise the vehicle on a lift, allow all four wheels to rotate freely, then start the engine, and check the shift lever operation.
30. Enter the anti-theft codes for the audio system and the navigation system (if equipped). Set the clock (on vehicles without navigation).
31. Do the power window control unit reset procedure.
