RDX L4-2.3L Turbo (2008)
Transmission Position Switch/Sensor: Testing and Inspection
Transmission Range Switch Test
1. Make sure you have the anti-theft codes for the audio system and the navigation system (if equipped).
2. Disconnect the negative cable from the battery, then disconnect the positive cable.
3. Remove the battery hold-down bracket, and remove the battery cover, the battery, and the battery tray.
4. Remove the battery base.
5. Disconnect the transmission range switch harness connector.
6. Check for continuity between terminals at the harness connector. There should be continuity between the terminals indicated in the following table
for each switch position.
7. The transmission range switch test is finished if the test results are OK.
If there is no continuity between any terminals, go to step 8.
8. Disconnect the transmission range switch connector.
9. Check for continuity between terminals at the switch connector. There should be continuity between the terminals indicated in the following table
for each switch position.
