RDX L4-2.3L Turbo (2008)
12. Install the fuel rail mounting nuts (G).
13. Connect the connectors on the injectors, and install the harness holder on the fuel rail.
14. Connect the quick-connect fitting.
15. Turn the ignition switch ON (II), but do not operate the starter. After the fuel pump runs for about 2 seconds, the fuel rail will be pressurized.
Repeat this two or three times, then check for fuel leakage.
16. Reinstall the injector cover, and connect the throttle body 6P connector.
17. Reinstall the charge air cooler.
18. Clear any stored DTCs with the HDS.
