RDX L4 Turbo (2008) Fuel Pressure Release Service and Repair
3. Start the engine, and let it idle until it stalls.
NOTE: If any DTCs are stored, clear and ignore them.
4. Turn the ignition switch OFF.
5. Remove the fuel fill cap.
6. Disconnect the negative cable from the battery.
7. Remove the charge air cooler cover and intake air duct (airflow tube).
8. Remove the quick-connect fitting cover (A).
9. Check the fuel quick-connect fitting for dirt, and clean it if needed.
10. Place a rag or shop towel over the quick-connect fitting (A).
