RDX L4-2.3L Turbo (2008)
Fuel Tank Unit: Service and Repair
Fuel Tank Unit Removal and Installation
Fuel Tank Unit Removal and Installation
Special Tools Required
Fuel sender wrench 07AAA-S0XA100
Removal
1. Relieve the fuel pressure.
2. Remove the fuel fill cap.
3. Fold the rear seat down, then remove the left rear door sill trim.
4. Pull back the carpet to expose the access panel.
5. Remove the access panel (A) from the left side of the floor.
6. Disconnect the fuel tank unit 4P connector (B).
7. Disconnect the quick-connect fittings (C) from the fuel tank unit.
8. Using the special tool, loosen the locknut (A).
9. Remove the locknut (A), and lift up the fuel tank unit (B) from the fuel tank. Then disconnect the transfer tube (C).
