RDX L4-2.3L Turbo (2008)
2. Test-drive the vehicle on a level road: Decelerate (with the throttle fully closed) from an engine speed of 2,500 rpm down to 1,000 rpm with the
transmission in S position 1st or 2nd gear.
3. Repeat step 2 several times.
4. Turn the ignition switch OFF.
5. Turn the ignition switch ON (II), and wait 30 seconds.
How to End a Troubleshooting Session (required after any troubleshooting)
1. Reset the PCM with the HDS.
2. Do the PCM idle learn procedure.
3. Turn the ignition switch OFF.
4. Disconnect the HDS from the DLC.
NOTE: The PCM is part of the immobilizer system. If you replace the PCM, it will have a different immobilizer code. In order for the engine to
start, you must rewrite the immobilizer code with the HDS.
