RDX L4-2.3L Turbo (2008)
11. Remove the bolt (D), and remove the PCM assembly (E).
12. Remove the cover (A), and the bracket (B) from the PCM (C).
13. Install the parts in the reverse order of removal.
14. Turn the ignition switch ON (II).
15. Manually input the VIN to the PCM with the HDS.
NOTE: DTC P0630 "VIN Not Programmed or Mismatch" may be stored because the VIN has not been programmed into the PCM; ignore it, and
continue this procedure.
16. USA, Canada models: If the READ DATA (engine oil life) failed in step 7, go to step 19. Otherwise, go to step 17.
17. USA, Canada models: Select the PGM-FI system with the HDS.
18. USA, Canada models: Select the REPLACE PCM MENU, then WRITE DATA and follow the screen prompts.
NOTE: If the WRITE DATA indicates FAILED, continue with this procedure.
19. Select IMMOBI system with the HDS.
20. Enter the immobilizer code with the PCM replacement procedure in the HDS; it allows you to start the engine.
21. USA, Canada models: If the TP POSITION CHECK failed in step 6, clean the throttle body, then go to step 22.
22. USA, Canada models: If the READ DATA failed in step 7 or the WRITE DATA failed in step 18, replace the engine oil and engine oil filter, then
go to step 23.
23. Select PGM-FI system and reset the PCM with the HDS.
24. Update the PCM if it does not have the latest software.
25. Do the PCM idle learn procedure.
26. Do the CKP pattern learn procedure.
