RDX L4-2.3L Turbo (2008)
^
If a clicking sound is heard, the valve is OK. Reconnect the connector, and install all removed parts.
^
If no clicking sound is heard, go to step 12.
12. Remove A/T clutch pressure control solenoid valve
13. Remove the ATF joint pipes (A), O-rings (B), ATF pipe (D), and gasket (E).
14. Check the fluid passage of the solenoid valve for contamination.
15. Connect a jumper wire from the negative battery terminal to A/T clutch pressure control solenoid valve C connector terminal No. 2, and connect
another jumper wire from the positive battery terminal to connector terminal No. 1. Make sure clutch pressure control solenoid valve C moves.
16. Disconnect one of the jumper wires, and check valve movement at the fluid passage in valve body mounting surface. If the valve binds or moves
sluggishly, or if the solenoid valve does not operate, replace A/T clutch pressure control solenoid valve C.
17. Clean the mounting surface and fluid passage of the solenoid valve body and transmission housing.
18. Install the 8 x 53 mm ATF joint pipe (A) with the filter end into its mounting hole (B).
