RDX L4-2.3L Turbo (2008)
8. Jump the SCS line with the HDS, then turn the ignition switch OFF.
NOTE: This step must be done to protect the PCM from damage.
9. Disconnect PCM connector A (44P).
10. Check for continuity between ignition coil relay 4P socket terminal No. 3 and body ground.
Is there continuity?
YES - Repair short in the wire between ignition coil relay 4P socket terminal No. 3 and PCM (A6).
NO - Go to step 11.
11. Check for continuity between ignition coil relay 4P socket terminal No. 3 and PCM connector terminal A6.
Is there continuity?
YES - The system is OK at this time. Check for loose or poor connections at the ignition coil relay and the PCM (A6).
NO - Repair open in the wire between ignition coil relay 4P socket terminal No. 3 and the PCM (A6).
