RDX L4-2.3L Turbo (2008)
Repairs and Inspections Required After a Collision: Service and Repair
SRS Component Replacement / Inspection After Deployment
Component Replacement/Inspection After Deployment
NOTE:
-
Before doing any SRS repairs, use the HDS SRS menu method to check for DTCs.
-
Check the front passenger's weight sensors after a vehicle collision.
-
After a vehicle collision, do the ODS unit operation check. See: Air Bag Systems/Testing and Inspection/Programming and Relearning/ODS Unit
Operation Check
-
Do not replace the ODS unit unless it is physically damaged or a specific DTC was found daring troubleshooting.
After a collision where the seat belt tensioners deployed, replace these items:
-
SRS unit
-
Seat belt tensioners
-
Seat belt buckle tensioners
-
Front impact sensors
After a collision where the front airbag(s) deployed, replace these items:
-
SRS unit
-
Deployed airbag(s)
-
Seat belt tensioners
-
Seat belt buckle tensioners
-
Front impact sensors
After a collision where the side airbag(s) deployed, replace these items:
-
SRS unit
-
Deployed side airbag(s)
-
Side impact sensor(s) (first) for the side(s) that deployed
-
Side impact sensor(s) (second) for the side(s) that deployed
-
B-pillar lower trim
-
Complete seat frame
-
Side airbag bracket
After a collision where a side curtain airbag has deployed, replace the items for the side(s) that deployed:
-
SRS unit
-
Deployed side curtain airbag(s)
-
Seat belt tensioner(s)
-
Side impact sensor(s) (first)
-
Side impact sensor(s) (second)
-
Roll rate sensor
-
Roof trim
-
A-pillar trim
-
B-pillar lower trim
-
C-pillar trim
-
Front grab handle
-
Rear grab handle
-
All related trim clips
-
Sunvisor
After a moderate to severe side or rear collision, inspect for any damage on the side curtain airbag or other related components. Replace the components
as needed.