RDX L4-2.3L Turbo (2008)
Ignition Switch: Testing and Inspection
Ignition Switch
Test
SRS components are located in the area. Review the SRS component locations and precautions and procedures before performing repairs or servicing.
1. Make sure you have the anti-theft codes for the audio system and the navigation system (if equipped).
2. Disconnect the negative battery cable.
3. Remove the steering column covers.
4. Disconnect the 7P connector (A) from the ignition switch (B).
5. Check for continuity between the terminals in each switch position according to the table.
6. If the continuity checks do not agree with the table, replace the ignition switch.
7. Enter the anti-theft codes for the audio system and the navigation system (if equipped). Set the clock (on vehicles without navigation).
