RDX L4-2.3L Turbo (2008)
Alternator: Removal and Replacement
Alternator Removal and Installation
Removal
1. Make sure you have the anti-theft code for the audio system and the navigation system (if equipped). Make sure the ignition switch OFF.
2. Disconnect the negative cable from the battery.
3. Remove the drive belt.
4. Remove the clip (A), then remove the coolant reservoir (B) from the holder.
5. Remove the clips (A), then remove the support rod clamp bracket (B).
6. Disconnect the A/C condenser fan motor connector (A), then remove the A/C condenser fan shroud assembly (B).
7. Disconnect the alternator connector (A) and BLK wire (B), then remove the harness clamp (C) from the alternator.
